EN
7
E
Horizontal Stabilizer Installation
1. Slide the horizontal tail (
A
) into the slot at the rear of the fuselage until the
retaining clip clicks. Ensure the control horn and the two support struts are
facing down.
2. Snap the left and right support struts (
B
) onto the ball-links (
C
).
3. Bind your aircraft to the model and power on the aircraft to ensure the
elevator servo is centered before adjusting and connecting the elevator
linkage.
4. Snap the elevator control linkage (
D
) on the ball-link (
E
).
5. Ensure the elevator and rudder servo arms are in the correct position, then
adjust the linkage to center them.
Disassemble in reverse order.
A
B
C
D
Model Assembly
Continued
Aileron Counterbalance and Wing Tip Guard
Installation
1. Carefully press the included wing tip guard (
A
) into the wing slot until it is
fully seated.
2. Carefully align the counterbalance (
B
) and seat it into the recess.
3. Secure the counterbalance into place with the included
2.5 x 6mm screw (
C
).
4. Repeat aileron counterbalance and wing tip guard installation for the
opposite wing.
Disassemble in reverse order.
A
B
2.5 X 6mm
C
Handle Installation
1. Carefully apply medium CA to the handle. Use only one or two drops to
prevent CA glue from running.
2. Carefully press the handle (
A
) into the recess in the wing until the handle is
fully seated.
A
