EN
5
* Failsafe
If the receiver loses transmitter communication, the failsafe will activate. When activated, failsafe moves the throttle channel to its preset
failsafe position (low throttle) that was set during binding. All other channels move collectively and actively to place the aircraft in a slow descending turn.
Binding
General Binding Tips
• The included receiver has been specifically programmed
for operation of this aircraft. Refer to the receiver manual
for correct setup if the receiver is replaced.
• Keep away from large metal objects while binding.
• Do not point the transmitter’s antenna directly at the receiver while binding.
• The orange LED on the receiver will flash rapidly
when the receiver enters bind mode.
• Once bound, the receiver will retain its bind settings
for that transmitter until you re-bind.
• If the receiver loses transmitter communication, the failsafe will
activate. Failsafe moves the throttle channel to low throttle. Pitch
and roll channels move to actively level the aircraft in flight.
• If problems occur, refer to the troubleshooting guide or if needed,
contact the appropriate Horizon Product Support office.
General Binding Tips
The BNF Basic version of this airplane includes SAFE Select technology, enabling you to choose the level of flight protection. SAFE mode includes angle limits and
automatic self leveling. AS3X mode provides the pilot with a direct response to the control sticks. SAFE Select is enabled or disabled during the bind process.
With SAFE Select disabled the aircraft is always in AS3X mode. With SAFE Select enabled the aircraft will be in SAFE Select mode all the time, or you can assign a
switch to toggle between SAFE Select and AS3X modes.
Thanks to SAFE Select technology, this aircraft can be configured for full-time SAFE mode, full-time AS3X mode, or mode selection can be assigned to a switch.
IMPORTANT:
Before binding, read the transmitter setup section in this manual and complete the transmitter setup table to ensure your transmitter is properly
programmed for this aircraft.
IMPORTANT:
Move the transmitter flight controls (rudder, elevators, and ailerons) and the throttle trim to neutral. Move the throttle to low before and
during binding.
You can use either the bind button on the receiver case or the conventional bind plug to complete the binding and SAFE Select process.
When using the auxiliary BEC from an ESC installed in the bind port of the receiver, unplug it to use bind plug.
A bind plug extension has been provided in BNF models. It will be labeled and located in the battery compartment for easy access.
Using Bind Button
Using Bind Plug
SAFE Select Enabled
SAFE Select Enabled:
The control surfaces cycle back and forth
twice
with
a slight pause at neutral position every time the receiver is powered on.
Press and hold Bind
Button
Connect Power
Lower Throttle
Release Bind Button
Orange Flashing LED
Bind TX to RX
SAFE Select Enabled
SAFE Select Enabled:
The control surfaces cycle back and forth
twice
with a
slight pause at neutral position every time the receiver is powered on.
Install Bind Plug
Remove Bind Plug
Lower Throttle
Connect Power
Bind TX to RX
Orange Flashing LED
BIND
BIND
SAFE Select Disabled
SAFE Select Disabled:
The control surfaces cycle back and forth
once
every time the receiver is powered on.
Press Bind Button
Lower Throttle
Connect Power
Bind TX to RX
Release Bind Button
Orange Flashing LED
SAFE Select Disabled:
The control surfaces cycle back and forth
once
every time the receiver is powered on.
SAFE Select Disabled
Install Bind Plug
Connect Power
Lower Throttle
Remove Bind Plug
Bind TX to RX
Orange Flashing LED
BIND
BIND
