EN
DRACO 2.0m
6
Landing Gear Installation
1. Install two 5mm ID washers (
A
) and one wheel onto each axle of the
landing strut.
2. Secure the wheels in place with one 3.5mm ID washer (
B
) and M5 nylon
locknuts (
C
), using a 5mm nut driver.
3. Install the landing gear assembly (
D
) on the fuselage and secure in place
using M4 x 20mm screws (
E
).
4. Remove the paper from the double side stick tape and install the foam
cover (
F
) onto the center of the main gear assembly.
Disassemble in reverse order.
Model Assembly
D
M4 X 20mm (4)
E
A
B
5mm lock nut
M3 X 20mm
C
Tail Wheel Installation
1. Remove the two screws to remove the two small plastic covers (
A
) (left and
right side).
2. Install the tailwheel assembly (
B
) with two M3 x 20mm screws and M5
nylon locknuts.
IMPORTANT:
Do not over tighten the 3mm screws and M5 nuts. Over
tightening will prevent the tail gear from pivoting up and down.
3. Reinstall the small rear plastic covers. (extra set in parts bag are the same
as removed from the aircraft).
4. Install the tailwheel springs (
C
) using needle nose pliers. Attach each spring
to the tail wheel assembly steering arm first, then attach the other end to
the steering arm on the fuselage.
Disassemble in reverse order.
5mm washer (2)
A
5mm
lock nut
C
3.5mm washer
B
F
