10
EN
Aft er Flying
3
Power off the transmitter.
Remove the fl ight battery immediately after fl ight
and fully charge before storing.
1
2
• Read the instruction manual carefully (especially the Troubleshooting section if you’re having problems).
• Small, smooth control inputs are best. Quickly moving the stick just produces instability and no real fl ight
control.
• Make sure the fl ight battery is fully charged before each fl ight. It’s better to run the fl ight battery down
to 50% or lower before recharging. A good, fully charged battery should provide for approximately 8 minutes
of fl ight time. If your fl ight time falls below 4 minutes, your battery may need to be replaced.
• Keep the helicopter dry and clean. Carpet lint, pet hair, dirt, etc, can restrict the motor and controls, giving
reduced power and control response times.
• Make sure the canopy is connected to the mounting posts. A loose canopy will cause the helicopter to shake.
• The helicopter must be sitting motionless to initialize the gyro stabilization system after connecting the fl ight
battery. If you are holding the helicopter in your hand or moving it around, it may not initialize properly.
Disconnect the fl ight battery, then reconnect the battery and place the helicopter on the landing skids.
• Make sure that the stabilizer/fl ybar is free to teeter up and down. This is what stabilizes the top rotor
system. If the stabilizer/fl ybar is restricted, your CX4 helicopter will not fl y correctly.
How to be a Successful Pilot
Содержание Blade CX4
Страница 1: ...RTF READY TO FLY Instruction Manual Bedienungsanleitung Manuel d utilisation Manuale di Istruzioni...
Страница 58: ...58 IT...
Страница 59: ...59 IT...