horiba B-711, Инструкция по эксплуатации

Страница: 24 / 34

16
7 Special Setting Mode
The special setting mode enables the meter setting and special operations.
To enter the special setting mode, press and hold the MEAS switch for over
3 seconds in the measurement mode. All the LCD items appear, then the
meter enters the special setting mode.
Tip
To exit the special setting mode with no setting change, press the ON/
OFF switch to turn OFF and ON again.
* Pressing the CAL switch continuously
switches the display in turn.
"7.1 Temperature display mode" (page 18)
Displays the ambient temperature measured using an
internal temperature sensor.
"7.2 Calibration point setting (only for B-712/B-
713)" (page 19)
Used to select the calibration points.
"7.3 Display digit setting (only for B-712/B-713)"
(page 20)
Used to select the coefficient (0.01 to 9.90) for
multiplying compensation. The values after
compensation are displayed as results.
The initial setting is 1.00.
"7.4 Sensor voltage display mode" (page 21)
Displays the voltage output from the sensor.
"7.5 Initialization mode" (page 22)
All settings and calibration data are reset to the
factory default values.
Automatically
All items
appear.
CAL switch*
MEAS
switch
CAL switch*
MEAS
switch
CAL switch*
MEAS
switch
CAL switch*
MEAS
switch
CAL switch*
MEAS
switch