User Manual - HS-1900B Electric Sweeper
8
3
Operation Guide
3.1 Check Before Operation
Before starting the operation, please conduct a regular inspection of the sweeper to ensure that the
sweeper can operate normally.
Before starting the sweeper, please fill up the water in the water tank. The water inlet is located
on the car shell on the left side of the control panel.
Water Inlet
Caution: If the environment of the sweeper is below 0°C, the water in the water tank must
be drained. The drain valve is located at the front of the vehicle bottom.
Check whether there is any foreign matter entangled on each brush of the sweeper, if so,
remove the foreign matter.
Use the key switch to start the sweeper and observe the electricity meter to ensure that the
voltage is within the normal range and the electricity is sufficient to complete the operation.
Test run the sweeper, check whether the driving system (especially the brake system) and the
cleaning system are normal, and pay attention to whether the sweeper makes abnormal noises
during the whole process.
