Installation into Panel
1.
Refer to the drawing above.
2.
Locate position in panel for mounting of the monitor. Assure that there is
adequate space begin the panel. Allow extra space (0.5 in. behind and on
each side) for air ventilation.
3.
Cut a rectangular hole in the panel. Clean and deburr.
Dimensions: 21.13” (536mm) W x 16.70” (424mm) H ; +/- .020”
4.
Separate the rear collar from the unit by removing the 14 nuts.
5.
Insert the unit into the front of the panel and re-attach the collar.
6.
Tighten all 14 nuts to a torque of 24 inch-pounds to assure a water-tight seal between the poron bezel
gasket on the monitor and equipment panel.
HIS will not assume liability for damage to internal elec-
tronics due to improper installation.
Cleaning
Any standard glass cleaner can be used to clean the touchscreen or pro-
tective safety glass window. Always spray the glass cleaner on the cloth or
towel and then clean the touchscreen. Glass cleaner sprayed directly on
the monitor could possibly leak inside a non-sealed unit and cause dam-
age.
Vinegar or ammonia will not hurt the touchscreen. Again, spray the cloth and
then clean the touchscreen.
14
