background image

 

Lubrication

The motor is equipped with bearings,
which have been lubricated for the life of
the motor. The addition of lubricant could
cause damage. 

Therefore, do not add

lubricant to either motor bearing.

The agitator is equipped with two ball

bearings that should be lubricated period-
ically by a Hoover Factory Service Center
or an Authorized Hoover Warranty Service
Dealer (Depot).

Service

To obtain approved HOOVER ser-
vice and genuine HOOVER parts,

locate the nearest 

Hoover Factory

Service Center or Authorized
Hoover Warranty Service Dealer
(Depot) 

by:

checking the Yellow Pages

under “Vacuum Cleaners 
Household” OR 

checking the list of Factory

Service Centers provided

with this cleaner OR 

calling l-800-944-9200 for an

automated referral of
authorized service outlet
locations (U.S. only)

Do not 

send your cleaner to The

Hoover Company in North Canton

for service, this will only result in

delay.

If further assistance is needed,

contact The Hoover Company
Consumer Response Center, North
Canton, Ohio 44720

Phone: 

In Canada, 

contact Hoover Canada,

Burlington, 

Ontario 

 

 Phone:

l-800-263-6376.

Always identify your cleaner by the

complete 

model number when

requesting information or ordering
parts. (The model number appears
on 

the bottom of the cleaner.)

If you have a

p r o b l e m

This appliance was inspected thorough-

ly and was in good operating condition
when it was shipped from the factory. if
a minor problem occurs, it usually can

Possible cause

Possible solution

Not firmly plugged in

Plug unit in firmly

No voltage in wall plug.

Check fuse or breaker.

Blown fuse/tripped breaker

 Replace fuse/reset breaker

Possible cause

Possible solution

Bag full.

Replace paper bag.

Obstruction in nozzle connector,
hose or wands.

R e m o v e   o b s t r u c t i o n .

Secondary filter dirty.

Clean filter.

Suction regulator improperly set.

Reset suction regulator.

Hose not properly connected to

cleaner

Ensure hose is properly connected.

Possible cause

Possible solution

Hose power cord not firmly

plugged in.

Plug firmly into receptacle on
cleaner base.

Broken or worn belt.

Rep/ace belt.

Nozzle sealed to carpet.

Open suction regulator.

Possible cause

Possible solution

Low cleaner suction.

See section “Cleaner suction low”.

Obstruction in nozzle connector.

Remove obstruction.

Agitator not running.

See 

section 

“Agitator won’t run”

Agitator brushes worn.

Replace brushes.

Full One Year

Warranty

( D o m e s t i c   U s e )

Your HOOVER@ appliance is warranted

in normal household use, in accordance

with the Owner’s Manual against original
defects in material and workmanship for
a period of one full year from date of

purchase. This warranty provides, at no
cost to you, all labor and parts to place

this appliance in correct operating con-
dition during the warranted period, This
warranty applies when the appliance is

purchased in the United States includ-
ing its territories and possessions, or in
Canada or from a U. S. Military
Exchange. Appliances purchased else-

where are covered by a limited one year
warranty which covers the cost of parts
only. This warranty does not apply if the
appliance is used in a commercial or

rental application.

Warranty service can only be obtained
by presenting the appliance to one of
the following authorized warranty ser-
vice outlets. Proof of purchase will be
required before service is rendered.

1. Hoover Factory Service Centers.

2. Hoover Authorized Warranty
Service Dealers (Depots).

This warranty does not cover pick up
delivery, or house calls; however, if 
mail your appliance to a Hoover Factory
Service Center for warranty service,
transportation will be paid one way.

While this warranty gives you specific

legal rights, you may also have other
rights which vary from state to state.

If further assistance is needed, or if

there are questions concerning this war-

ranty or the availability of warranty ser-

vice outlets, write or phone the

Consumer Response Center, The
Hoover Company, 101 East Maple St.,
North Canton, Ohio 44720.
Phone l-330-499-9499.

For an automated referral of authorized
service outlets in the U.S.A., phone

l-800-944-9200.

In Canada, contact 

Hoover Canada,

Burlington, Ontario 

 

l-800-263-6376.

9

Содержание Futura S3559










Отзывы: