Honeywell Optimus 5100, Руководство пользователя

Страница: 25 / 64

3 - 13
Suspend Mode
Suspend Mode suspends terminal operation. The terminal appears to be “off” when in Suspend Mode.
The terminal is programmed to go into Suspend Mode automatically when inactive for a specified period
of time. You can set this time period in the Power setting.
To suspend and resume operation, press the Power button. You may also press the front Scan key to
wake a suspended device unless the battery door has been removed and replaced.
Note: You should always put the terminal in Suspend Mode when you change the battery pack; see Changing the
Main Battery Pack on page 3-10. When you replace the battery door, press the
Power
button to wake the
device. Pressing the front Scan key will not wake up the device when the battery door is replaced.
Troubleshooting Suspend/Resume
If the terminal does not wake when you press the Power button, the main battery might be too low to
resume operation. To check, remove the battery and install a fully charged battery or connect the terminal
to a Optimus charging peripheral.
Changing the Memory Allocation
You can adjust file storage vs. program memory in System Properties.
1. Select Start -> Settings -> Control Panel -> System -> Memory tab.
2. Move the slider to adjust the memory allocation and select OK . The changes take effect
immediately.
Care and Cleaning of the Optimus Terminal
When needed, clean the engine window and the LCD display with a clean, non-abrasive, lint-free cloth.
The terminal can be cleaned with a damp cloth.
Optimus 5100 Technical Specifications
Operating System Microsoft Windows CE 5.0 Core
Development
Environment Optimus 5100 SDK
Application Software Tools and Demos