Honeywell Optimus 5100, Руководство пользователя

Страница: 22 / 64

3 - 10
Changing the Main Battery Pack
Before installing a battery pack, press the Power key to put the terminal in Suspend Mode (see page 3-
13) so that operations are suspended before removing the main power source. Always put the terminal
in Suspend Mode prior to changing the battery. The 5100 is shipped with the battery separate from the
unit. You will need to remove the battery door, insert the battery, and replace the battery door. Refer to
the instructions included in
Installing the Main Battery section (page 2-1 ).
Note: The battery door must be installed prior to booting the unit.
Charging Options
When the battery is installed in the terminal, you can use any of the peripherals listed below to charge the
battery.
• Optimus HomeBase Device (see page 9-1)
• Optimus Comm/Charge Cable; Connecting the USB Charging/Communication Cable (see page 7-2)
You may charge the device using the USB connection if you do not have a wall adapter. There are two
options that allow either 100mA or 500mA of current over the USB connection. Access the option by
selecting
Start -> Settings -> Control Panel -> Power -> USB Charging .
To fully charge the Li-ion battery before installing it in the terminal, use the
• Optimus QuadCharger Device (see page 10-1) or insert the battery in the spare battery charging well
in the back of the Optimus HomeBase.
Charging Time
The standard capacity 2200mAh Li-ion battery pack requires four hours to charge to full capacity, while
the extended capacity 3300mAh pack requires six hours.
Managing Main Battery Power
Data and files saved on the Optimus terminal may be stored in RAM memory; therefore, maintain a
continuous power supply to the terminal to help prevent data loss. When you remove a battery pack, insert
another charged battery pack in the Optimus. If the main battery pack is low, insert the terminal into a
charging peripheral to power the terminal and begin recharging the battery.
Note: If the main battery is low and the terminal is in Suspend Mode, pressing the
Power
button does
not
wake
the Optimus 5100 terminal; you must replace the discharged battery with a fully charged battery, or apply AC
power to the terminal.