N200-310-00
I56-6591-001
+
+
+
+
1
2
3
4
+
Patents Pending
EU Declaration of Conformity
Hereby,
Life Safety Distribution GmbH declares
that the radio equipment type
NRX-WS-RR / NRX-WS-WW
is in compliance
with directive 2014/53/EU
The full text of the EU DoC can be requested from:
address on the loop. Select a number between 01 and 159 (Note: The
number of addresses available will be dependent on panel capability,
check the panel documentation for information on this).
Important
Set the loop address on the sounder module
Before
inserting the batteries
PROGRAMMING
Configuring the Sounder settings
Volume setting
The sounder has 3 possible volume settings: Low, Medium, High.
The sounder is supplied configured with the volume set to HIGH
(factory default setting). To change the volume to a different setting
requires a separate programming operation using the
Device Direct
Command
in
AgileIQ
(See
Radio Programming and Commissioning
Manual
- ref. N200-306-00 for details.)
1) Take the un-commissioned sounder, ensure that the address is set
to 00 (default setting).
2) Insert the batteries.
3) Select the
Device Direct Command
tab in AgileIQ, double click
on the screen to reveal the options and follow the instructions to
configure the sounder volume setting.
It is recommended that the sounder’s output volume configuration is
noted for future reference on the sounder label after programming:
OUTPUT VOLUME: High __ Medium __ Low __
Tone setting
The sounder is supplied configured with the tone setting 8 (factory
default setting), with the second stage tone as 2 (see tone table). To
change the tone to a different setting requires a separate programming
operation using the
Device Direct Command
in
AgileIQ
(See
Radio
Programming and Commissioning Manual
- ref. N200-306-00 for
details.)
1) Take the un-commissioned sounder, ensure that the address is set
to 00 (default setting).
2) Insert the batteries.
3) Select the
Device Direct Command
tab in AgileIQ, double click
on the screen to reveal the options and follow the instructions to
configure the sounder tone settings.
It is recommended that the sounder’s tone configuration is noted for
future reference on the sounder label after programming:
1st STAGE TONE No: __ 2nd STAGE TONE No: __
Note: Remove the batteries from the device after setting the tone
and/or volume if the system commissioning operation is not
about to be done.
Commissioning
1) Ensure that the correct address has been set on the device.
2) Insert the batteries.
3) Fit the sounder in its base (as shown in
Figure 2
).
To load network parameters into the RF sounder, it is necessary to link
the RF gateway and the RF sounder in a configuration operation. At
commissioning time, with the RF network devices powered on, the RF
gateway will connect and programme the sounder and all the other RF
devices in the system with the necessary network information. The RF
sounder then synchronises with its other associated devices as the RF
mesh network is created by the gateway. (For further information, see
the
Radio Programming and Commissioning Manual
- ref. N200-
306-00.)
NOTE:
Do not try to commission more than one gateway system
at a time in an area.
Figure 4: Battery Installation and Rotary Address Switches
NOTE
POLARITY
ROTARY
ADDRESS
SWITCHES
4a
4b
4c
4d
EN54-25: 2008 / AC: 2010 / AC: 2012
- Components Using Radio Links
EN54-3: 2014 - Fire Alarm Devices: Sounders
0359 18
DOP-IRF028
Notifier Fire Systems by Honeywell
Pittway Tecnologica S.r.l. Via Caboto 19/3
34147 TRIESTE, Italy
NRX-WS-[xx]
[xx] =
RR Red WW White
