Honeywell N431X, Руководство пользователя

Страница: 52 / 222

Character Activation Mode
You may use a character sent from the host to trigger the engine to begin
scan-ning. When the activation character is received, the engine continues
scanning until either the Character Activation Laser Timeout (page 3-11), the
deactiva-tion character is received (see Deactivation Character on page 3-11),
or a bar code is transmitted. Scan the following On bar code to use character
activation, then use Activation Character (following) to select the character you
will send from the host to start scanning. Default = Off.
* Off
On
Activation Character
This sets the character used to trigger scanning when using Character
Activation Mode. On the ASCII Conversion Chart , page A-3, find the hex
value that represents the character you want to use to trigger scanning.
Scan the following bar code, then use the Programming Chart to read the
alphanumeric combination that represents that ASCII character. Scan
Save to finish .
Activation Character
End Character Activation After Good Read
After a bar code is successfully detected and read from the engine, the laser
can be programmed either to remain on and scanning, or to turn off. When
End Character Activation After Good Read is enabled, the laser
3-10