Honeywell N431X, Руководство пользователя

Страница: 111 / 222

When Check Character is set to Validate and Transmit , the engine only
reads Matrix 2 of 5 bar codes printed with a check character, and will
trans-mit this character at the end of the scanned data. Default = No
Check Character.
* No Check Character
Validate, but Don’t Transmit
Validate and Transmit
Matrix 2 of 5 Redundancy
If you are encountering errors when reading Matrix 2 of 5 bar codes, you
may want to adjust the redundancy count. Redundancy adjusts the num-
ber of times a bar code is decoded before transmission, which may
reduce the number of errors. Note that the higher the redundancy count,
the lon-ger it will take to decode the bar code. To adjust the redundancy,
scan the Matrix 2 of 5 Redundancy bar code below, then scan a
redundancy count between 0 and 10 on the Programming Chart inside
the back cover of this manual. Then scan the Save bar code. Default = 0.
Matrix 2 of 5 Redundancy
Matrix 2 of 5 Message Length
Scan the bar codes below to change the message length. Refer to
Message Length Description (page 6-2) for additional information. Mini-
mum and Maximum lengths = 1-80. Minimum Default = 3, Maximum
Default = 80.
Minimum Message Length
Maximum Message Length
6-19