Honeywell LeaderLine DPR 100 C, Руководство по эксплуатации продукта

Страница: 189 / 228

10-9
10. TROUBLESHOOTING
10.2.5 SYMPTOM : The chart is inoperative
POSSIBLE CAUSE CORRECTIVE ACTION
No message is displayed or in case of
analog input basic actions, "NO INPUT" is
displayed for the considered input.
Check "sensor", "actuation" configuration and switch
position on your input card.
Print inhibit is activated by digital input.
Check the "print action" configuration in the digital
input matrix and status of digital inputs.
Chart is incorrectly installed.
Install chart correctly.
(See figures on pages 2-8 and 2-9)
Chart is torn.
Advance chart beyond torn sections.
Chart drive gear train is damaged.
Replace chart cassette assembly.
Power supply
Check voltage on power supply.
(Refer to CK 113). If voltage is not correct, replace
power supply module.
Chart drive logic If no other action is fixed, replace mother board.
(Refer to CK 152)
"END PAPER" message
When you see "END PAPER" message on the
display ("end of paper" message), the recorder
informs you that the chart arrives at the end.
To remove this message, press until you read
"PAPLG=..." (chart length) and press ENTER .
After that, the "END PAPER" message disappears.
10.2.6 SYMPTOM : The print carriage is inoperative
POSSIBLE CAUSE CORRECTIVE ACTION
Carriage drive cable tension is incorrect. Check and adjust drive cable tension.
(Refer to CK 126)
Bad connection Check wiring connections.
(Refer to pages 2-5 to 2-7)
Carriage drive cable is broken.
Replace carriage drive cable. (Refer to CK 126)
Carriage drive motor Make an auto-test. (Refer to CK 114)
Refer carriage drive motor. (Refer to CK 119)
Carriage drive motor logic Replace mother board. (Refer to CK 152)
Power supply Check voltage on power supply.
(Refer to CK 113). If voltage is not correct, replace
power supply module.