Honeywell LeaderLine DPR 100 C, Руководство по эксплуатации продукта

Страница: 186 / 228

10-6
10. TROUBLESHOOTING
10.2.2.1.4 Printing of information message
!
The figure 10-3 ref. 4 shows the message.
!
Time and date,
!
Software version,
!
Chart identification number.
10.2.2.1.5 Checking the answer of the pen tip
!
The figure 10-3 ref. 5 shows the printing test.
!
See 2 horizontal lines written in 6 colors.
10.2.2.1.6 Test for motor torque margins and mechanical slacks
!
The figure 10-3 ref. 6 is composed of 3 serrated parts and each of them cut with a black line in
the middle.
!
The first serrated part and the beginning of the black line are executed with subvoltage, and
movements are accelerated. (Coil included)
10.2.2.1.7 Chart advance and print test
!
The figure 10-3 ref. 6 shows the test for chart advance with a diagram written every 20 mm.
10.2.2.1.8 Adjustment check
!
An adjustment check for carriage and colors is executed at the end of the diagnostic.
!
For the carriage: on the right the set value (22 or 23) and on the left the relative error (error
values between - 3 and +3 included are correct).
!
For the color: on the right the set value (20 or 21) and on the left the relative error (error
values between - 3 and +3 included are correct).
10.2.2.2 Running in multipoint recorder
!
For 2 hours
!
Consumption : 1 m of chart paper
!
The recorder prints a message every cycle, indicating the number of remaining cycles,
(22 cycles at all),
!
The 2 different graphs are the following (See figure 10-3 ref 7 and 8)
!
For each cycle, the adjustment is controlled for carriage and colors.
!
The adjustment check result is the following: on the left the carriage control and on the right
the color control.
!
At the end, the recorder executes a new DIAGNOSTIC, then indicates an end message with
recapitulation of defective adjustment check .