Honeywell kaltecSoft PW50AS, Руководство по установке

Страница: 19 / 42

Honeywell GmbH 19 MU1H-1408GE23 R0305
GB
Disturbance Cause Remedy
No brine intake Incorrect settings at the control valve Check the control valve settings
(
☞
Chapter 9)
Sewerage tube is blocked Clean and, if necessary, replace sewerage tube
(CS)
Min. operating pressure not available Min. operating pressure is 1.8 bar
(
☞
Chapter 3)
Permanent discharge into
sewerage tube
Back pressure in sewerage tube is too high Clean and, if necessary, replace sewerage tube
(CS)
Control head is defective Call the Technical Customer Service on
(49) 6261 810
High salt consumption Incorrect settings at the control valve Check the control valve settings
(
☞
Chapter 9)
Blending has been set incorrectly Check blending valve and mixing ratio
(
☞
Chapter 7.8)
Too much water in the storage tank
☞
Fault ““too much water in the storage tank””
No or insufficient salt con-
sumption
Incorrect settings at the control valve Check the control valve settings
(Chapter 9. )
Blending has been set incorrectly Check blending valve and mixing ratio
(
☞
Chapter 7.8)
Brine tube is contaminated Clean brine tube
Saline water Min. operating pressure not available Min. operating pressure is 1.8 bar
(
☞
Chapter 3)
Incorrect settings at the control valve Check the control valve settings
(
☞
Chapter 9)
Brine valve is contaminated or defective Clean and, if necessary, replace brine valve
(CS)
1
Control head is defective Call the Technical Customer Service on
(49) 6261 810
Differential pressure at the
device is too high
Construction of the device is too small Call the Technical Customer Service on
(49) 6261 810
Blending has been closed too widely Check blending and mixing ratio
Pressure water supply is not smooth Check functioning of the pressure reducer in
front of the device
Install pressure reducer in front of the device
(
☞
Chapter 6.1)
1. CS = Customer Service