Honeywell JOSI-DBC012-N11, Руководство по установке

Страница: 27 / 40

ACUIX
TM
Fixed Dome User Guide
Document 800-01605 Rev A 27
04/08
Adjusting the Focal Length and Focusing the Lens
1. Remove the lower dome if it has been installed.
2. Loosen the top locking screw and then rotate the barrel to adjust the focal length. See
Figure 2-3 for color cameras. See Figure 2-4 for WDR cameras.
3. Loosen and then move the bottom locking screw (closest to the camera board) to
adjust the focus. See
Figure 2-3 for color cameras. See Figure 2-4 for WDR cameras.
4. Install the lower dome (see Installing the Lower Dome on page 23 ).
5. Check the picture. If the focus is clear, go to Vari-focal Auto Iris Configuration (Color
Cameras) on page 27 . If the focus is not clear, remove the lower dome, then go back
to step 2 and repeat until you are satisfied with the picture clarity. You may have to
readjust the camera angle.
Vari-focal Auto Iris Configuration (Color Cameras)
To configure the Vari-focal Auto Iris settings (adjust the iris), see Figure 2-3 . Use the
potentiometer, located on the lower left corner on the top or front of the camera board
on color cameras, to regulate to regulate the Auto Iris lens.
1. Remove the lower dome if it has been installed.
2. Set the DIP switches. See the section for your camera type for the DIP switch
functions and adjustment methods (
Color Cameras on page 28 for color cameras and
Wide Dynamic Range (WDR) Cameras on page 30 for wide dynamic range cameras) .
3. Disconnect service monitor when you are finished adjusting the camera.
4. Install the lower dome.