Honeywell JOSI-DBC012-N11, Руководство по установке

Страница: 25 / 40

Document 800-01605 Rev A 25
04/08
2
Adjusting the Camera
Caution In certain camera positions, components on the rear camera board
can come in contact with parts of the gimbal, which can cause
damage to the camera board.
Note You cannot adjust the camera with the lower dome installed. But the lower
dome must be installed to check the adjustments. You may have to install and
remove the lower dome several times while adjusting the camera.
Adjusting the Camera Angle
To adjust the ACUIX™Camera angle:
1. Remove the lower dome if it has been installed.
2. Connect the service monitor cable (supplied) to the video monitor output (see
Figure 2-3 if you have a color camera and Figure 2-4 if you have a WDR camera) so
you can view the image from the camera.
3. Apply 11-16 VDC or 24 VAC power to the camera and monitor the video signal.
4. Adjust the camera carrier to the desired view by moving the gimbal in the V-shaped
slot (see
Figure 2-1 ).
a. Loosen the two Phillips screws that keep the camera carrier in place.
b. Move the camera carrier into the desired position.
c. Tighten the two Phillips screws.