Honeywell
5 Network Operations
Initialization
If IP Receiver is to be connected to a router, you must assign a static IP address that is not
occupied by other device for IP Receiver, and you can assign at most 2 IP addresses. After
performing the system configuration (see
System Configuration
on page
23
), configure the IP
addresses for IP Receiver by following these steps:
1.
Access the login page of IP Receiver System by entering
http://192.168.0.2
or
http://192.168.1.2
in IE (see
Figure 5-2
on page
28
for the login page).
2.
Log in IP Receiver System. For more information, see
Login
on page
28
.
3.
On the “Configuration” page, specify an unoccupied IP address in the field of
“IP_address1” for gigabit Ethernet port 1, and specify a second unoccupied
address in the field of “IP_address2” for gigabit Ethernet port 2. Click
Run
to save
the configuration.
The following figure shows the configuration page of IP Receiver (see
Configuration
on page
29
for more information).
Figure 5-1 Initial Configuration of IP Receiver
Note
“IP_address1” corresponds to the IP of gigabit Ethernet port 1, while
“IP_address2” corresponds to the IP of gigabit Ethernet port 2.
Do not
mix the two addresses during configuration.
27
