Honeywell HW-TG7FS, Инструкция по установке и эксплуатации

Страница: 35 / 40

LS10265-000HW-E:D 06/03/2021
27
56052901 – Rev B
Troubleshooting Quick Reference Table
Telguard Event LED Indication
Relay
Output
Radio
Message
Internal Action
STC *
Telguard System
Trouble
Conditions
ACFC PWR LED off. STC LED 2 flashes
continuously 1 time .
Optional Optional Switch to standby
battery if present,
monitor battery, monitor
AC for restoral. No action
on Panel Power.
LBC STC LED 2 flashes continuously
2 times .
Optional Optional Wait for LBC restoral,
charge battery.
LFC STC LED 2 flashes continuously
3 times.
Optional Optional Transmit alarm via radio
if necessary. When Telco
is restored, remove LFC
condition.
NSC STC LED 2 flashes continuously
4 times.
Optional None Continue to validate
signal strength, NSC will
restore when signal
returns.
RFC STC LED 2 flashes continuously
5 times .
Optional None Wait for RFC restoral.
DTF STC LED 2 flashes continuously
6 times .
Yes Yes Internal 30V supply
circuit failure.
PPF STC LED 2 flashes continuously
7 times.
No Yes Wait for PPF restoral.
Not Activated Activation LED 1 off. Yes None The Telguard will not
function until the first
signal is sent through
the Telguard to activate
the unit
Automatic Self-Test Radio LED 5 flashes during
transmit.
None Yes (Self-
test)
Send Self-test
information to central
station via TCC, return to
ready state.
Telguard Remote Query –
Communication Center
Activated by Customer
Service.
Radio LED 5 flashes during
transmit.
None Yes (Status
data)
Send Status data to the
TCC for review customer
service.
Telguard Enable and
Configuration Upload –
Radio LED 5 flashes during
transmit.
None Configuratio
n Data (Setup
data)
The Telguard sends
setup configuration to
the TCC and switches to
READY state to begin
operation.
Disable TX – Communication
Center initiated.
Radio LED 5 flashes when
transmitting.
Yes Yes (Status
data)
TX capability is disabled
until further notice. The
Telguard can still receive
radio signals from the
TCC.
Note: * If several trouble conditions are present, the STC LED will flash all applicable indications in sequence.