LS10265-000HW-E:D 06/03/2021
9
56052901
–
Rev B
Getting Ready
The Telguard device can only be activated when all necessary accounting information has been added to the
customer database located at the TCC (i.e., the unit has been registered). The database includes information
about the customer account, unit location, and system test plan information.
Dealer Account Establishment
A Dealer Account must be established prior to registration of any Telguard unit. This can be accomplished
by visiting
the necessary information under “Dealer Signup”.
This is a
one-time event and an acknowledgment from Telguard Customer Service will include a Dealer Account
Number that will be used for all Telguard Digital registrations. Telguard units can be registered and
activated once the Dealer Account has been established.
Pre-Installation Checklist
Before attempting to connect the Telguard device to the alarm panel, please make sure you have all the
proper parts before you go to the job site. The following items are shipped with each Telguard unit:
•
Telguard Cellular Communicator
•
UL Listed plug-in transformer
•
Cellular Antenna
•
12-foot antenna cable with mounting bracket
•
7-foot RJ 45 plug-to-plug cord
•
20-inch battery cable assembly with connector plug
•
Enclosure key lock
•
Pluggable screw terminal blocks (2, 3 & 6 position)
•
Quick Install Guide
•
Registration Form
•
Tamper switch (applicable to TG-7 units sold in Canada)
Note: The Telguard device registration must be completed in advance to avoid installation delays
You must also have certain installation test tools:
•
Screws and a screwdriver will be required to attach the Telguard unit and antenna to the wall.
•
To connect the STC relay outputs and trip input to the alarm panel, solid or stranded electrical wire will
be required. The terminal strips can accommodate solid or stranded wire from 14 to 22 gauge in size.
•
A standard telephone or lineman's butt-set is recommended for verifying communication between the
panel and the Telguard unit.