Performance Series DVR User Guide
______________________________________________________________________________________________
Document 800-04765 Rev A
69
06/09
Remote Software
Set up a Remote Connection
The administrator and up to eighteen additional users (four simultaneously)
can access the DVR remotely using software installed on a personal computer.
Configuring the DVR
1.
Press the SETUP key on the front of the DVR or remote control to log in.
2.
Select NETWORK > CLIENT CONFIGURATION (See the Client
Configuration section of this manual for more details).
3.
Change port settings or write down current port settings.
4.
Select SAVE to save current settings.
5.
Select NETWORK CONFIGURATION (see the Network Configuration
section of this manual for more details).
6.
Select or clear DHCP depending on your network (Ask your network
administrator for assistance).
7.
If DHCP is cleared - define the IP address and additional network
information.
8.
If DHCP is selected - write down the IP address supplied by the DVR
system.
Note
If the DVR does not display the IP Address after setting DHCP to ON,
Select Save to change the network and open Network Configuration
again.
9.
Select SAVE to save current settings.
