User Manual of Explosion-Proof PTZ Camera
50
5.
Draw area.
1)
Click
to draw a line on the image.
2)
Click the line to switch to the editing mode.
Drag an end to the desired place to adjust the length and angle of the line. And drag the
line to adjust the location.
6.
Configure the parameters for each defense region separately.
Direction:
Select the detection direction in the dropdown list, there are A<->B, A->B and
B->A selectable.
Sensitivity:
Range [1-100]. The value of the sensitivity defines the size of the object which
can trigger the alarm, when the sensitivity is high, a very small object can trigger the
alarm.
7.
Click
tab to enter the arming schedule setting interface. The time
schedule configuration is the same as the settings of the arming schedule for motion
detection. Refer to
Section
5.2.1 Configuring Motion Detection
8.
Click
tab to select the linkage method taken for the line crossing detection,
Notify Surveillance Center, Send Email, Upload to FTP/Memory Card/NAS, Trigger Alarm
Output and Trigger Recording are selectable. Refer to
Section
9.
Click
to save the settings.
5.3.5
Configuring Region Entrance Detection
Purpose:
Region entrance detection function detects people, vehicle or other objects which enter a
pre-defined virtual region from the outside place, and some certain actions can be taken when
the alarm is triggered.
Steps:
1.
Enter the Region Entrance Detection settings interface:
Configuration> Event > Smart Event> Region Entrance Detection
2.
Check the checkbox of
Enable
to enable the Region Entrance Detection function.
