7
FINAL INSTALLATION
Figure 5.5
Figure 5.9
Figure 5.4
Figure 5.8
Figure 5.7
Figure 5.6
Finial
Light Kit
Bulb
Motor Screw
Light Kit
Fitter Plate Screw
Blade Screw
Blade Washer
Blade Arm
Blade
9-pin Connector
Blade Arm
Light Pan
Fitter Plate
Fitter Plate Screw
4. Partially insert the blade screws along with blade washer through blade and into the blade arm. Tighten each blade screw
starting with the one in the middle. Repeat this step for the remaining blades and blade arms (Figure 5.4).
5. Install the blade arm to the underside of the motor assembly using the ten previously removed motor screws (Figure 5.5).
6. Remove one of the three fitter plate screws from the fitter plate and loosen the other two. Then lift the light pan and place
the two keyhole slots in the light pan over the two loosened fitter plate screws. Turn the light pan in a clockwise direction and
secure it using the previously removed fitter plate screw. Tighten all three fitter plate screws (Figure 5.6).
7. Remove one of the three light pan screws from the light pan and loosen the other two screws. Then, connect the 9-pin
connector from the fan to the 9-pin connectors from the light kit. Align the screw holes of the light kit over the loosened light
pan screws and turn in a clockwise direction. Replace previously removed light pan screw. Tighten all screws (Figure 5.7).
8. Install the three E26-base LED bulbs (Figure 5.8).
9. Remove the finial, finial cap, hex nut, and rubber washer from the threaded rod on the light kit (Figure 5.9).
Rubber Washer
Hex Nut
Finial Cap
