Mounting
It is recommended that the
Mimic LED Driver Cards
are mounted inside a Custom panel using suitable PCB
standoffs, there are 6-3mm PCB fixing holes provided on the card. The
Connection converters
are mounted
on 35mm DIN rails. The LEDs and associated wiring must also be contained inside the same enclosure for
mechanical protection.
"
The designer of the Custom panel in which the
Mimic LED Driver Cards
,
Connection converters
and LEDs are
mounted must ensure the panel enclosure is EMC compliant and is CE marked.
Cables
The internal connection from the
Connection converter
to each LED inside the Custom panel is made using
a standard PVC cable. Each LED can be positioned a maximum of up to
3m
cable distance away from the
terminals of a
Connection Converter
.
For recommendations on loop cable type refer to the manual supplied with the Vigilon control panel.
Earth
The Custom panel must be earthed. The loop cable screen must be continued through the Custom panel,
whether the earth is connected to the Custom panel or not.
"
Do not use any part of building structure for earthing.
Mains supply
The mains supply to the Custom panel must be via an unswitched 5A fused spur unit. A disconnect device
must be provided to disconnect both poles and must have a minimum gap of 3mm. The disconnect device
should be available as part of the building installation and must be easily accessible after installation is
complete.
&
Before removal of any card or disconnection of any cable from the Custom panel ensure both mains and battery supplies
are disconnected.
Battery supply
Data and Installation
Mimic LED Driver Card
2
4188-951_issue 2_01/12_Part 1_Mimic LED driver
FS2
3.15A(T)
Ceramic
(Anti Surge)
Battery Fuse
BT+
BT
-
+
RS485
0V 24V
-
BUZZER
DISABLE
DANGER
DO NOT
REMOVE
P5
FS2
P1
SW3
PB2
WD1
P14
P7
USB
FS3
2A(QB)
DANGER
WARNING
Removal of
cover exposes
live parts.
+
+
-
-
Master Repeat Card
Black
Red
Battery lead
Link lead
6V 7Ah Battery
6V 7Ah Battery
Leave the final connection of the battery for the Servicing organisation.
This connection is made during power up and commissioning.
You can use 1 - 12V 7Ah battery (VSRPT-BATT)
or 2 - 6V 7AH batteries
as shown.
(VSRPT-BATT-A3)
