NFS Supra
Page 14
HLS-MN-025 v.04
Installation and Operating Manual
www.honeywelllifesafety.es
www.hoeywelllifesafety.es
ZONE
INDICATORS
The system has a number of alarm detection zones which will correspond, in general, with
particular areas of the protected building.
In case of incidence in one of these zones, the zone led indicator, indicates their status. In case
of Fault, Disablement or Test in one zone, besides the yellow zone LED, the general state LED
of the specific event will light. If you enable access to Level 2 (Operator), LED zone will flash
latched (with the same frequency) as the general status LED of the relevant zone.
Zone Alarm
(Red):
This led indicates that there is a device under
alarm condition in this zone
.
-Led
flashing
: There is a
detector
in alarm.
-Led
On
: There is a
call point
in alarm.
Check the alarm cause and press the
Reset
key (Access level 2) to make the system return to its normal status.
Zone Fault/Disabled/Test
(Yellow):
The relevant zone is in fault, test or disabled.
-
Led flashing quickly (
and Fault led also on
): The zone is in fault condition. Check the zone wiring. Once the fault cause has been
cleared, press the
Reset
key (Access level 2) to make the system return to its normal status.
-Led On (
and Disablement led on too
). The zone is disabled. Enable the zone by pressing the
Zone
key (Access level 2) until the
zone yellow led is off.
-Led On (and Test led On too) / (flashing slowly with test led On in Access level 2): The relevant zone is being tested. Press the
Zone
key (Access level 2) until the zone yellow led is off.
Indicadores
de Zonas
Operation
