Honeywell EQUIP HD4HDIH, Руководство пользователя

Страница: 27 / 90

HD4 EQUIP Series True Day/Night Rugged IP Network Camera User Guide
Document 800-07496V2 Rev A 27
11/2011
Connecting to a Network via CAT5 Ethernet Connector
The main video connection for your camera is made through the Ethernet network
connection. Connect the CAT5 Ethernet connector (see
Figure 2-5 on page 24 ) to your
network using an Ethernet (10Base T, 100Base TX) cable.
Note You can connect your camera to a network or connect it directly to a PC or
laptop using a crossover cable between the camera and the PC or laptop.
Step 8. Sealing the wiring
To prevent moisture from entering the housing, you should apply the appropriate sealant
around the conduit entry and mounting screws.
Step 9. Adjusting the Camera
Connecting to a Video Monitor
The local video out connection (see Figure 2-5 or Figure ) is available as a test output and
should be used during installation to position, aim, and focus the camera, as needed.
Connect from the local video out connector on your camera to the video input connector
on your spot monitor.
Adjust the FOV (Field of View)
To adjust the your camera:
1. Verify that power is supplied to the camera.
Note If your installation involves a 24V AC power source, then please wait
approximately 60 seconds after connecting to a power source for video to
appear on the local video out.
2. Reinstall the gimbal by inserting the black tabs into the black clips on the enclosure
base.
3. Connect the supplied video cable to the local video out connector to view the video
signal on a standard monitor (see Figure 2-9 ) for the location of the local video out
connector).
4. Loosen the setscrew that locks the gimbal assembly in place (see Figure 2-10 ) to
adjust the horizontal rotation.