1
REPLACING BATTERIES
Your RF remote control operates with two alkaline batteries (type AA).
If the symbol
is shown flashing on the display, the batteries have to be
replaced.
If the batteries are completely empty, the display will go blanc. Therefore,
replace the batteries of the RF remote control in time.
Replace the batteries as follows:
Remove the back cover of the RF remote control by moving the
back cover down a few millimeters (see figure 1) and then lift up
the back cover.
Remove the old batteries from its holder.
Place a new set of batteries in the holder as shown in figure .
Replace the back cover of the RF remote control by placing the
tabs A and B of the back cover (figure ) in the according notches
of the housing (figure ).
Push the back cover up to secure it.
The current time and day of the week must be set again after replacement
of the batteries. However, this is only necessary in case a clock
programme is used.
Note: Don’t throw empty batteries away but dispose of them as chemical
waste.
1.
.
.
4.
.
