Honeywell AUTOCUBE 8200, Руководство пользователя

Страница: 16 / 56

8 AutoCube 8200 User Guide
Install the AutoCube Camera
1. Angle the clamp on the top of the pole perpendicular to the pole. Turn the knob
to loosen the clamp.
2. Insert the ball of the camera into the clamp. Make sure the Honeywell logo on
the front is right side up. Adjust the camera to the correct angle (A) from the
pole (see
Dimensions on page 5).
3. Turn the knob to tighten the clamp. Be sure it is tight enough so that the
camera will not move.
4. Attach the USB cable at the top of the pole to the camera. Secure the cable to
the camera by tightening the screws by hand.
Note: Be sure the camera is horizontal to the measurement area and aimed directly at the
area. No roll and no yaw.
Note: Keep the protective foam on the camera until installation is finished.
Mount the Stand
Recommended 2 person operation.
1. Rotate the stand assembly upright on the mounting surface. Align stand base
to previously drilled holes.
Note: If cables exit through the bottom of the pole, pull them through the mounting surface.
Caution: Do not remove the protective foam during installation.
Knob to tighten
or loosen clamp
USB cable to
camera