Honeywell AlarmNet IGSMV, Инструкция по установке и настройке, Страница: 25 / 64

Section 3: Programming the IGSMV
3-5
PROMPTS ENTRY OPTIONS DESCRIPTION
Important Information Regarding Primary and Secondary Accounts (Questions 12-18)
Account information is provided by the central station administrator. If the control panel
supports secondary account reporting, you will need secondary account information. The City ID,
CS ID or Subscriber ID of the secondary account must differ from that of the primary account.
12
Primary City ID
(??)_
[01-99]
Enter the 2-digit primary city ID, 01-99 (decimal).
13
Primary CS ID
(??)
[01-FE] Enter the 2-digit primary central station ID number,
01-FE (HEX).
14
Primary Sub ID
(????)
[0001-9999]
Enter the 4-digit subscriber account number, 0001-
9999 (decimal).
15 En. 2nd CS Y/N
(N)_
[Y], [N]
Applicable only if the control panel supports Central
Station #1 and #2 Category Enable reporting for the
LRR device (e.g., VISTA-128BP, FA1660C, etc.).
Used if reporting to a second central station is desired.
If [N], go to Prompt 19: "Device Address."
16 2nd City ID
(??)_
[01-99]
Enter the 2-digit secondary city ID, 01-99 (decimal).
17 2nd CS ID
(??)_
[01-FE]
Enter the 2-digit second central station's ID number,
01-FE (HEX).
18
2nd Sub ID
(????)_
[0001-9999] Enter the 4-digit subscriber account number for the
second central station, 0001-9999.
19 Device Address
(03)_
[01-30] In ECP mode, the IGSMV communicates with the
control panel as a Long Range Radio (LRR) device.
Enter the appropriate ECP device address. For
VISTA-10 and VISTA-20 series control panels, use
address 03. For other controls, see the control panel’s
Installation and Setup Guide.
NOTES:
1. When programming the control panel, enable the
LRR output.
2. The device address must be unique from the
"Keypad Address" entered in Prompt 22, and the
Multi-Mode Address entered in Prompt 11.
UL / ULC
Remote access has not been evaluated by UL or ULC.
20 RemoteAccess
Y/N
(N)_
[Y], [N]
Press [Y] to allow the end user to access their system
via a website. Availability of this service is controlled
by the dealer via the web-based programming tool on
the AlarmNet Direct website.
21
Direct Wire Y/N
(N)_
[Y], [N]
Applies only to VISTA-128BP/250BP and FBP Series
control panels, and FA1660C and 1700C Series control
panels.
Enables Direct Wire Downloading over IP.
If [N], and if Prompt 20: "Remote Access" is disabled,
skip to Prompt 23: "Supervision."
22 Keypad Address
(28)_
[01-30]
Must be programmed if using either the Remote
Access feature or Direct Wire downloading.
NOTES:
1. This address must also be programmed as an alpha
keypad in the control panel or an AUI (advanced
user interface) type device, if a full enhanced
graphic interface to the system is desired and the
control panel supports it. DO NOT connect an
actual keypad (or any other device) assigned to this