14
4. <Installing the unit>
Put the unit on so that the rear of it’s upper bracket could fit in inner bento position at rear of lower bracket.
And then, fix the front of bracket with 2 pcs. hexagon bolt (M8X20).
Disk plate
X6
HEX. Bolt
M8X20
IMPORTANT NOTICE
When you install the unit on the ceiling, DO NOT USE pan head screws sup-
plied with the unit.
You must use hexagon bolts (bigger than M8X35) and install firmly.
Screw
M6X20
Bolt
M8X35
M8 HEX. Nut
8mm
Washer
8mm
S-Washer
3. <Putting the disk plate>
Put the supplied disk plates on six holes which are not used for installing the unit to prevent the water or
foreign substance from entering.
2. <Fixing the lower bracket>
After you decide the location to install the unit, fix the lower bracket with 6 pcs. screws M6X20 which are
supplied with the unit. Refer to [Dimensional drawing] for the position of holes.(Page 9)
