Honda WB20XT2, Руководство пользователя

Страница: 72 / 132

8-7
dummyhead dummyhead
WB20XT2•WB30XT2 IGNITION SYSTEM
OIL ALERT UNIT
REMOVAL/INSTALLATION
Disconnect the
Oil Alert
unit connectors (1).
Remove the 6 x 12 mm bolt (2) and Oil Alert unit (3).
Install the
Oil Alert
unit and bolt.
Hold the Oil Alert unit against the boss (4) of the stay,
and then tighten the bolt.
Route the wire harness properly (page 2-10).
IGNITION COIL AIR GAP
CHECK/ADJUSTMENT
Remove the fan cover (page 5-2).
Insert the thickness gauge (1) of proper thickness
between the ignition coil (2) and the flywheel (3).
• Avoid the magnet part of the flywheel when
adjusting.
• Adjust the ignition coil air gap equally on both sides.
If measured clearance is out of specification, adjust the
air gap.
Loosen the two 6 x 25 mm bolts (4).
Insert the thickness gauge of proper thickness between
the ignition coil and flywheel.
Push the ignition coil firmly against the flywheel and
tighten the ignition coil bolts securely.
Remove the thickness gauge.
(1)
(3)
(2)
(4)
IGNITION COIL AIR GAP:
0.2 – 0.6 mm (0.01 – 0.02 in)
(2)
(3)
(1)
(4)
0.2 – 0.6 mm
(0.01 – 0.02 in)
0.2 – 0.6 mm (0.01 – 0.02 in)