Honda GXE2.0H, Руководство пользователя

Страница: 66 / 71

7-8
dummyhead dummyhead
POWER UNIT
ROTOR SHAFT REMOVAL/INSTALLATION
TOOL FITTING
Install the following and place the assembly on wooden blocks [1].
– [2] Dowel pin (2)
– [3] Tool: Rotor guide (070PG-8A00100)
REMOVAL/INSTALLATION
Push the rotor guide [1] down without wooden blocks to release the rotor
shaft [2].
To install, insert the rotor shaft into the rotor guide while holding it securely
set with wooden blocks [3].
STATOR INSPECTION
Remove the PDU cover (page 5-2).
Disconnect the PDU 3P (Gray) connector [1].
Check for connector for loose contacts or corroded terminals.
Measure the coil resistance between the terminals of the stator side 3P
(Gray) connector.
Measure the insulation resistance between each connector terminal and the
motor housing and rotor shaft (with 1,000 VDC range in a insulation
resistance tester).
Replace the stator assembly if the coil resistance is out of specification, or if
the insulation resistance is abnormal.
[1]
[2]
[3]
[3]
[1]
[2]
[3]
CONNECTION: Red – White
Blue – Red
White – Blue
STANDARD: 65.5 – 72.5 mΩ (20°C/68°F)
RESISTANCE: 10 MΩ or more
Red Blue White
[1]