6-8
dummyhead
dummyhead
CONTROL UNIT
PDU MOUNT RUBBER CHECK
Check the mount rubbers [1] supported the PDU for cracks or tears by
pulling the PDU lightly. Also, check the stopper pin bolts [2] in between the
mount rubbers for excessive wear of breakage.
Do not apply more load to the mount rubbers than necessary.
If any abnormality is found, replace the rubbers and pin bolts as a set.
Check the stay clearance (page 6-7).
SWITCH INSPECTION
START/STOP SWITCH (Applicable type)
Check for continuity between the terminals of the START/STOP switch in
each switch position shown in the table below.
POWER SWITCH (Applicable type)
Check for continuity between the terminals of the 2P connector.
There should be continuity with the switch pressed and should be no
continuity with the switch released.
[1]
[2]
5
6
4
3
2
1
1
2
3
4
START
STOP
5
6
Terminal
Position
Содержание GXE2.0H
