Honda Motorcycle & Scooter India Pvt. Ltd.
58
CBR 250R
(1) Rear Axle Nut
(2) Drive Chain Lock Nut
(3) Drive Chain Adjusting Nut
(4) Chain Adjuster Index Marks
(5) Rear Edge of Adjusting Slot
5. Check rear axle alignment by making
sure the “Chain Adjuster Index Marks”
(4) align with the “Rear Edge of Adjusting
Slot” (5).
(4)
(1)
(2)
(3)
(5)
6. Tighten the rear axle nut to the specified
torque.
Rear axle nut torque:
88 N·m (9.0 kgf·m , 65 lbf·ft)
If a torque wrench is not used for this
installation, visit your nearest Honda dealer
as soon as possible to verify proper assembly.
7. Tighten the drive chain adjusting nuts
lightly, then tighten the drive chain lock
nuts by holding the drive chain adjusting
nuts with a spanner.
8. Recheck drive chain slack.
Wear Inspection:
Check the chain wear label when adjusting
the chain. If the “Red Zone” (6) on the label
aligns with the “Arrow Mark” (7) on the
chain adjuster plates after the chain has
been adjusted to the proper slack, the chain
is excessively worn and must be replaced.
The proper slack is :
20 - 30 mm (0.8 - 1.2 in)
Damage to the bottom part of the frame
may be caused by excessive drive chain
slack of more than:
50 mm (2.0 in)
Both left and right marks should
correspond. If the axle is misaligned, turn
the left or right adjusting nut until the
marks correspond on the rear edge of the
adjusting slots and recheck chain slack.
Содержание CBR250R
Страница 1: ...Honda Motorcycle Scooter India Pvt Ltd ...