Honda Acura NSX 1991, Руководство по обслуживанию

Страница: 858 / 1420

Rear Hatch Glass
Removal
CAUTION:
l
Use covers to avoid damaging the body.
l Wear gloves to remove and install the glass.
Do not damage the defroster grid lines.
l Take care not scratch or score the window molding.
1 .
2.
3 .
4 .
Remove the rear hatch from the body (page
Using an awl, make a hole through the glass
adhesive from the inside, at the top of the glass.
Push piano wire through the hole and wrap each
end around a piece of wood.
1 . Use a putty knife to scrape off all traces of old
adhesive and dams, then clean the rear hatch frame
and glass (new) surface with alcohol where new
adhesive is to be applied.
NOTE: Make sure the bonding surface is kept free
of water, oil and grease.
Apply the protective tape along the edge of the rear
CAUTION: Avoid setting the glass on its edges;
hatch frame as shown.
small chips may later develop into cracks.
With a helper holding the glass, pull the wire back
and forth in a sawing motion and carefully cut
through the adhesive along the top and the sides of
the glass.
CAUTION: Hold the piano wire as close to the
glass as possible to prevent damage to the frame.
FRAME
\
I n s t a l l a t i o n
NOTE:
Do not scrape down to the painted surface of the
hatch frame; damaged paint will interfere with pro-
per bonding.
Mask off surrounding before painting.
G L A S
REAR HATCH
FRAME
20-32