Honda Acura NSX 1991, Руководство по обслуживанию

Страница: 856 / 1420

Rear Window Molding
Replacement
1. Remove the rear window and wire harness. (page
2. Place the glass on its surface as shown.
CAUTION: Avoid setting the glass on its edges;
small chips may later develop into cracks.
3. With a helper holding the glass, carefully cut off the
upper and lower moldings.
i
ADHESIVE
NOTE: Be careful not to
cut the adhesive and dam
between the inner and
outer glass.
INNER GLASS
OUTER GLASS
‘ADHESIVE
4. Scrape all traces of old adhesive from the
chamfered edges of the glass.
NOTE: Be sure to scrape all traces of old adhesive
thoroughly.
5. Clean the glass surface with alcohol where the new
moldings are to be installed.
NOTE: Make sure the surface is kept free of water,
oil and grease.
6. With a brush, apply a light coat of glass primer
around the edge of the glass.
NOTE: Scrape off excess glass primer with a putty
knife after installing the new moldings.
OUTER GLASS
INNER GLASS
EXCESS PRIMER
: Apply primer here.
7. Degrease the inner surfaces of the new moldings
thoroughly, then apply a light coat of glass primer
to the surfaces.
NOTE:
Apply glass primer around the entire groove of
the new molding.
Do not apply glass primer to the outer surface.
8. Run a bead of adhesive in the molding grooves.
20-30