Honda Activa SCV110, Справочник по обслуживанию

Страница: 62 / 230

5-1
5. FUEL SYSTEM
SERVICE INFORMATION
GENERAL
SERVICE INFORMATION 5-1
TROUBLESHOOTING 5-2
AIR CLEANER HOUSING 5-3
CARBURETOR REMOVAL 5-4
CARBURETOR INSTALLATION 5-8
THROTTLE SWITCH 5-9
AIR SCREW ADJUSTMENT 5-10
FUEL TANK 5-11
SECONDARY AIR SUPPLY SYSTEM 5-12
5
ITEM
SPECIFICATIONS
Identification number
Venturi diameter
Main jet
Slow jet
Float level
Jet needle clip position
Air screw initial opening
Air screw final opening
Idle speed
PAIR control valve specified vacuum
PB16 x 1
16 mm (0.63 in)
#90
#35 x #35
11.7 ± 0.5 mm (0.46 ± 0.02 in)
3rd groove from top
1 7/8 turns out
4 turns out
1,700 ± 100 min –1 (rpm)
420 mmHg (16.54 in Hg)
• Gasoline is extremely flammable and is explosive under certain conditions. KEEP OUT OF REACH OF CHILDREN.
• If the engine must be running to do some work, make sure the area is well-ventilated. Never run the engine in an enclosed
area. The exhaust contains poisonous carbon monoxide gas that may cause loss of consciousness and lead to death.
Run the engine in an open area or with an exhaust evacuation system in an enclosed area.
• Bending or twisting the control cables will impair smooth operation and could cause the cables to stick or bind, resulting
in loss of vehicle control.
• Work in a well ventilated area. Smoking or allowing flames or sparks in the work area or where gasoline is stored can cause
a fire or explosion.
• If the vehicle is to be stored for more than one month, drain the float bowl. Fuel left in the float bowl may cause clogged jets
resulting in hard starting or poor driveability.
• For the fuel level sensor removal/installation and inspection, refer to section 18.
• Before removing the carburetor, place an approved fuel container under the carburetor drain tube, loosen the drain screw and
drain the carburetor.
• When disassembling fuel system parts, note the locations of the O-rings. Replace them with new ones on reassembly.
• After removing the carburetor, wrap the intake port of the engine with a shop towel or cover it with a piece of tape to prevent any
foreign material from dropping into the engine.
SPECIFICATIONS