93
Hard-Surfaced track
Sympton
Action
Begin with the standard setting. If the suspension is too stiff/soft, adjust according to the chart below.
Lower the rear end (to impove front wheel stability) by increasing Race Sag (reduce spring preload).
Example: – Turn both compression damping adjusters and, especially, rebound damping adjuster to a stiffer setting.
– Increase standard Race Sag (+0.2 to 0.4 in/5 to 10 mm).
Adjust to a stiffer position because mud build-up increases your CRF’s weight
Example: – Adjust the compression and rebound damping adjusters to stiffer settings.
– Install the optional stiff spring.
– Reduce standard Race Sag (–0.2 to 0.4 in/5 to 10 mm).
Sand track
Mud track
Stiff suspension
Soft suspension
Suspension bottoms
1. Test softer low speed compression adjustment.
2. If it still feels stiff, further test softer low and high speed compression adjustments simultaneosly.
Rear Suspension Adjustment
Adjustments for Type of Track
Symptoms and Adjustment
•
Always begin with the standard settings.
•
Turn the low speed compression and rebound adjusters in one-click increments, and the high speed compression adjuster in 1/6 turn increments at a time. Adjusting
two or more clicks or turns at a time may cause you to pass over the best adjustment. Test ride after each adjustment.
•
If, after setting, the suspension feels unusual, find the corresponding symptom in the table and test stiffer or softer compression and/or rebound damping adjustments
until the correct settings are obtained as described.
Suspension feels stiff on small
bumps
1. Test softer high speed compression adjustment.
2. If it still feels stiff, further test softer low and high speed compression adjustments simultaneosly.
Suspension feels stiff on large
bumps
1. Test softer high and low speed compression adjustments and rebound adjustment simultaneously.
2. If it still feels stiff, replace the spring with a softer spring (optional) and begin with the standard settings
to softer settings.
1. Test stiffer high and low speed compression adjustments simultaneously
2. If it still feels soft, replace the spring with a stiffer spring (optional) and begin with the standard settings
to softer settings.
1. Test stiffer high and low speed compression adjustments and rebound adjustment to stiffer settings
simultaneously.
1. Test stiffer high speed compression adjustment.
2. If it still bottoms, test stiffer high and low speed side compression adjustments and replace the spring with
a stiffer spring (optional) if necessary.
1. Test stiffer low speed compression adjustments.
2. If it still bottoms, test stiffer high and low speed compression adjustments and replace the spring with
a stiffer spring (optional) if necessary.
1. Test softer rebound damping adjustment.
2. If it still bottoms, test stiffer high and low speed compression adjustments and softer rebound damping
adjustment and replace the spring with a stiffer spring (optional) if necessary.
Entire travel too stiff
Entire travel too soft
Rear end sways
Suspension bottoms at landing
after jumping
Suspension bottoms after landing
Suspension bottoms after end of
continuous bumps
