Honda 1994 NSR 250 SP, Руководство по установке

Страница: 20 / 48

1-18
3. Exchanging the front fork spring
i) Put bike on front paddock stand and remove the front tyre/mudguard.
ii) Turn the pre-load adjusters to the minimum and loosen the bolt of the top yoke. Detach the
front fork bolt, slowly raise the bottom case and push the damper COMP out of the fork pipe.
iii) Remove the fork bolt from the damper COMP.
iv) Push the spring seat down, remove it from the damper COMP and exchange the spring.
[CAUTION]
•
When raising the bottom case, protected it with a cloth to prevent oil from scattering.
•
Never loosen the locknut of the damper COMP.
•
Carrying out exchanging R/L sides separately.
•
Closely coiled side of the spring should face downwards.
•
Check the oil level before fixing the spring.
Tightening torque’s:
Fork bolt:
2.3kgf.m
Front accelerator: 6.0kgf.m
Top yoke bolt: 2.3kgf.m
Front mudguard: 1.0kgf.m
v) Apply oil so as not to damage the ‘O’ ring, then fit the fork bolt.
vi) After fitting the front spring, detach the paddock stand and check the movement of the front
spring.
vii) Fix the preload adjuster back to the standard position.
viii) Try running and adjust preload and Comp if necessary.