Honda 1994 NSR 250 SP, Руководство по установке

Страница: 17 / 48

1-15
2. Installing the rear sets.
i)
Loosen the lock nut of the master cylinder brake rod joint, then exchange it for the kit rod
end.
ii) Fit the brake pedal and foot peg to the L. hanger in the kit.
iii) Fit the gear change lever and foot peg to the R. hanger in the kit.
Tightening torque foot peg hanger: 2.7kgf.m
The length of the R. tightening bolt is different from L.:
R: 8x50 L: 8x55
[CAUTION]
•
Install pedals after greasing moving parts.
•
Ensure that pedals work smoothly after tightening foot peg hanger.
iv) Fit the master cylinder to the R. step holder.
Tightening torque: 1.2kgf.m
v) Fix the R. rear set to the frame body.
vi) Install the L. foot peg hanger with a collar adjusted.
Thickness of collars UP/LOW UP: t = 10 LOW: t = 15
Length of bolts R/L R: 8x28 L: 8x34
Tightening torque Foot peg hanger: 2.6kgf.m
vii) Fasten the gear change arm/rod end temporarily to the change bolt and fit them to pedals
and the change spindle shaft
viii) Adjust the position of each pedal as you prefer. After adjusting the change pedal, re-adjust
and tighten them so that the change arm is level with the change bolt tightening stay.
Tightening torque
6mm bolt: 1.5kgf.m 6mm nut: 1.2kgf.m
[CAUTION]
•
If you wish to equip a foot guard plate to the R. hanger, make one for yourself or repair the one
for RS250R.
•
Foot guard plate: 50641-NF5-950