www.homeright.com
English
11
Suction Tube Kit (optional)
Suc
tion
Tu
be
Su
ctio
n T
ub
e
S
uc
tio
n T
ub
e
1
2
3
Squeeze a small amount of oil (included,
3-in-One
®
oil or similar) into the pick-up tube
port and the return port. Plug in sprayer and
squeeze trigger 3-5 seconds to lubricate piston
with oil.
Remove container and pick-up tube.
Push the suction tube onto the intake and
return ports of the cylinder housing. Clamp
suction tube to longer pick-up tube port.
Su
ct
io
n
Tu
be
Su
ct
io
n
Tu
be
Su
ction Tube Suc
tion
Tu
be
S
uc
tio
n T
ub
e
4
5
Push the pick-up tube into the hose that is
attached to the longer cylinder housing port.
If suction tube has curl memory, run the suction
tube under warm water to uncurl and release
memory.
Slide the suction tube through the container
clamp. Immerse the suction tube into paint or
stain and secure clamp to side of container.
Install pick up tube once suction tube and pick
up tube are secured in clamp.
7
Hold the sprayer below the level of the paint.
This will speed up the priming. The paint/stain
may need additional thinning if the sprayer will
not prime.
8
Aim the sprayer at a piece of scrap board or
cardboard. Squeeze the trigger and hold until
all air is out of the system and material is
flowing freely out of the sprayer tip. Normal
priming time is one minute. If it takes longer
than two minutes, stop. The sprayer may need
to be lubricated or the material may need to be
thinned.
9
The suction tube allows you to spray at any
angle, straight up or straight down, great for
floors and ceilings.
6
Turn the flow control knob counter-clockwise to
maximum.
C820425D.f_MAN_Pro50-55_EN-FR-ES.indd 11
8/15/11 10:41 AM
