19
5.
The touch screen control panel and circuit board can be removed to facilitate access to the
back of the circuit board for the final wiring by depressing the 2 tabs at the top of the panel
and pulling it forward and upward. Connect the wires from the solenoid control box(es) to
the terminal block on the back of the circuit board as noted below and re-connect the
touch screen control panel and circuit board by snapping it back into position. Ensure
there is a little play in the wires and that none of the wires are pinched, etc. Tighten the
cable glands to solidly secure the cables.
6.
Connect the solenoid wire(s) from the control box(es) to the solenoid valves. Place the
rubber gasket (in parts bag) between the solenoid valve coil (green) and the plug on the
end of the wire from the control box. Secure the connection with the screw provided.
START UP THE SYSTEM
The Fleck 5810XTR2 Control Valve (1) comes with a 10
foot long electrical cord. Plug the control valve power
cord into the Control Valve (1).
The electrical port on the
Control Valve (1) is located on the right side of the valve
(when you are facing the control panel), just behind
the tab used to remove the valve cover. It is a bit
tricky to find… see the diagram to the right:
Plug in the power cord(s) from the Solenoid Wiring Kit
control box(es), and the Control Valve (1) into standard,
grounded 120 volt (60 Hz) electrical outlets. Be certain
that the outlets are uninterrupted and not controlled by a
