HomeMatic HmIP-STH, Инструкция по монтажу и руководство по эксплуатации

Страница: 45 / 50

45
Restore factory settings
1x long red
lighting Transmission
failed or duty
cycle limit is
reached Please try again (see
sec. „7.2 Command
not confirmed“ on
page 42 or „7.3
Duty cycle“ on page
43).
6x long red
flashing Device defec-
tive Please see your app
for error message or
contact your retailer.
1x orange and
1 x green
lighting (after
inserting
batteries) Test display Once the test
display has stopped,
you can continue.
8 Restore factory settings
The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the temperature and
humidity sensor please proceed as follows:
• To remove the sensor (B) from the frame, take
hold of the sides of the sensor and pull it out (see
figure 2) .