6
OPERATION OF CURRENT DEVICE
IMPORTANT SAFETY INSTRUCTIONS
NOTE
The power supply cord with this
air conditioner contains a current
detection device designed to
reduce the risk of fire. Please
refer to the section Operation
of Current Device for details.In
the event that the power supply
cord is damaged, it cannot be
repaired-it must be replaced
with a cord from hOme
®
. Please
contact customer service at
1-800-898-3002.
Avoid fire hazard or electric shock.
Do not use an extension cord or
an adaptor plug. Do not remove
any prong from the power cord.
The power supply cord contains a
current device that senses damage
to the power cord. To test your
power supply cord do the following:
1. Plug in the Air Conditioner.
2. The power supply cord will have
TWO buttons on the plug head.
Press the TEST button, you will
notice a click as the RESET
button pops out.
3. Press the RESET button, again
you will notice a click as the
button engages.
4. The power supply cord is now
supplying electricity to the unit.
For Your Safety
Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
Prevent Accidents
To reduce the risk of fire, electrical shock, or injury to persons when using
your air conditioner, follow basic precautions, including the following:
• Be sure the electrical service is adequate for the model you have chosen.
This information can be found on the serial plate, which is located on the
side of the the cabinet and behind the grill.
• If the air conditioner is to be installed in a window, you will probably
want to clean both sides of the glass first. If the window is a triple-track
type with a screen panel included, remove the screen completely before
installation.
• Be sure the air conditioner has been securely and correctly installed
according to the installation instructions in this manual. Save this manual
for possible future use in removing or installing this unit.
• When handling the air conditioner, be careful to avoid cuts from sharp
metal fins on front and rear coils.
Electrical Information
The complete electical rating of your new room air conditioner is stated
on the serial plate. Refer to the rating when checking the electrical
requirements.
• Be sure the air conditioner is properly grounded. To minimize shock and
fire hazards, proper grounding is important. The power cord is equipped
with a three-prong grounding plug for protection against shock hazards.
• Your air conditioner must be used in a properly grounded wall receptacle.
If the wall receptacle you intend to use is not adequately grounded
or protected by a time delay fuse or circuit breaker, have a qualified
electrician install the proper receptacle. Ensure the receptacle is
accessible after the unit installation.
• Do not run air conditioner without side protective cover in place. This
could result in mechanical damage within the air conditioner.
• DO NOT USE AN EXTENSION CORD OR AN ADAPTOR PLUG.
• Always make sure the RESET button is pushed in for correct operation.
• The power supply must be replaced if it fails reset when either the TEST
button is pushed, or it cannot be reset. A new one can be obtained from
hOme
®
.
• If power supply cord is damaged, it cannot be repaired. It MUST be
replaced by one obtained from hOme
®
. Please contact customer service
at 1-800-898-3002.
This air conditioner is designed to be operated under condition as follows:
WARNING
WARNING
WARNING
WARNING
Power supply
cord with 3-prong
grounding plug
and current
detection device
Do Not, under any
circumstances, cut,
remove, or bypass the
grounding prong.
Grounding type wall
receptable
(Applicable to the unit adopts
current detection device only )
NOTE
NOTE: Performance may be reduced outside of these operating temperatures.
Cooling
Operation
Outdoor Temp:
64 - 109
O
F / 18 - 43
O
C
Outdoor Temp:
23 - 76
O
F / -5 - 24
O
C
Indoor Temp:
62 - 90
O
F / 17 - 32
O
C
Indoor Temp:
32 - 80
O
F / 0 - 27
O
C
Heating
Operation