21
accurate so that the backwash cycle will occur at the correct time of the day and so that the
diagnostic and data gathering functions of the control valve will be accurate.
If the day and time are flashing, it means that there has been a power failure and the day
and time need to be checked.
To change the time of day, touch the day and time display in the top left corner of the home
screen and the following screen will appear:
Touch the grey box associated with the year. 2 blue arrows will appear. Touch the blue
arrow on the left to decrease the year. Touch the blue arrow on the right to increase in the
year. Adjust the year by touching the arrows until it is correct.
Similarly, touch the grey boxes associated with the month and day and use the arrows to
adjust the month and day settings until they are correct
Set the hour, minutes, and pm/am in the same manner.
When you are satisfied that all of the settings are correct, press the checkmark icon on the
bottom right corner of the screen. To cancel your changes and return to the home screen,
press the “X” icon at any time.
Your system has been pre-programmed to regenerate based on its capacity and your water
conditions, and to perform this process at 12:30am in the morning when it is unlikely that
water will be required in the building. In most cases, this will occur every 5 to 7 days, but this
will vary depending on your water conditions and water demand. If water is required during
the regeneration process, untreated water will be permitted to flow to meet your service
needs. You can alter the time of day that the regeneration process occurs if 12:30am is not
ideal for you. If you have another automatic backwashing/regenerating water treatment
