9
HomewerksWW.com
EXISTING CONSTRUCTION INSTALLATION INSTRUCTIONS (continued)
4. Position fan housing so edge of fan is flush with ceiling board/
sheetrock. Do not flush mount housing with joist.
NOTE: HOUSING MUST BE INSTALLED FLUSH WITH
CEILING BOARD/SHEETROCK OR THE GRILLE MOUNTING
SPRING WILL NOT BE LONG ENOUGH TO INSERT INTO
THE SLOTS INSIDE THE FAN HOUSING.
4
1
2
5. Fig. 5A - Secure the fan housing to joist with suspension
brackets using M4x30 wood screws (AA) (included).
(Joist spacing of less than 21-1/4 in.)
Fig. 5B - Mounting with joist spacing of 21-1/4 in. to 23-1/2 in.
5
5A
5B
6. Secure the suspension bracket (C) to fan housing using
screw (CC) (included). Secure suspension brackets (D, E)
with screws (BB) (included).
6
7. Remove junction box cover as shown in illustration number 7.
Using quick connect ports, connect house wires to the switch
and fan. Please refer to the wiring diagram on page 5 to ensure
proper wire connections are being made.
Note: Do not use metal wall plate with the switch, as it may
cause interference with the fan operation.
ATTENTION:
The switch included with this ventilation fan
requires a neutral wire connection. If a neutral line is not
present, one must be run by a qualified electrician.
If you require assistance, please call 1-877-319-3757 before
attempting switch installation.
NOTE:
This switch is intended to only operate independently
with this bath fan. Connections to other electrical fixtures are
prohibited and could cause electrical issues.
7
