1
1
2
2
Note:
If an HAI automation system is being used, the controller system time is sent to the thermostat every
minute. This adjustment will have no effect.
15 Filter
reminder
The thermostat logs the amount of time the system fan has been running. When this setting reaches 0, the
thermostat will display a reminder to replace the filter. The setting is the amount of days (24 hours of system
operation) before this reminder is displayed.
Days - Counting down from 10 - 0
The filter reminder can be disabled by setting this item to 60.
16 System runtime (This week)
This item logs the amount of time (hours) that the heating and cooling system was in operation this week.
17 System runtime (Last week)
This item logs the amount of time (hours) that the heating and cooling system was in operation last week.
QUICK-REFERENCE SETUP GUIDE
This table displays each Installer Setup item with its default setting. The column labeled "CURRENT" can be
used to write down the current settings if any changes are made to the default settings.
Item Number
Description
Default
Current
00
Address
1
01
Communication mode
1
02
System options
0
03
Display options
1
04
Calibration offset
30
05
Cool setpoint limit
51
06
Heat setpoint limit
91
07
Not used
-
08
Not used
-
09
Cooling anticipator
4
10
Heating anticipator
4
11
Cooling minimum on/off time
8
12
Heating minimum on/off time
8
13
Not used
-
14
Clock adjust
30
15
Filter reminder
10
16
System runtime (This week)
-
17
System runtime (Last week)
-
