Holzstar ADH 2540 230V, Инструкция по эксплуатации

Страница: 16 / 26

16 ADH-Series | Version 1.02
Operation
Fig. 20: Adjusting the slitter shaft cover
Step 7: Release the clamping lever (D, Fig.21) to move
the stop to the desired position.
Step 8: Release the clamping lever (F, Fig.21) to set the
desired angle of the stop.
Fig. 21: Setting the workpiece stop
Step 9: Turn the handle (K, Fig.22) to adjust the chip re-
moval.
Abb. 22: Setting the chip removal
Step 10: Switch on the machine.
Step 11: Press the workpiece with one hand against the
dressing table and stop. Then use the second
hand to push the workpiece evenly on..
Fig. 23: Adjustment and material guidance Surface planing
Step 12: After finishing the operation, switch off the ma-
chine with the red stop button.
8.2 Thickness planing of workpieces
Step 1: Switch off the machine and disconnect it from the
power supply.
Step 2: Remove the workpiece stop by releasing the
clamping lever (D, Fig.21).
Step 3: Lift the cutter cover to the highest position.
Step 4: Swing the jointer plane table back by turning and
releasing the handle (L, Fig.24).
Fig. 24: Swivel work table
Step 5: Pull out the two brackets (H, Fig.25) of the suc-
tion hood.
NOTE!
The brackets (see Fig. 25) on the chip extraction
hood activate a safety switch on the machine. If this
safety switch is not activated, the machine cannot be
started!