Holzstar 5902423, Инструкция по эксплуатации

Страница: 15 / 38

Seetings
HBS Series | Version 1.02 15
Step 2: Slowly turn the top roller clockwise by hand. The
saw band should run centrally on the rubber
pads of the roller. Be careful not to grab the saw
blade.
Step 3: If the saw blade does not run in the middle, cor
-
rect the saw blade by turning the knob to the left
or right.
Step 4: Check the run of the saw blade on the roller. It
should rest in its full width on the rubber pad.
Fig. 21: Rotary knob for Inclination
Step 5: After completing the adjustments, fix everything
again and close both covers
Adjustment the saw blade tension
Step 1: Turn the handwheel to increase or decrease the
saw blade tension via a spring. Turn the adjust
-
ment knob clockwise to increase the blade ten
-
sion. Turning the knob counterclockwise decrea
-
ses the blade tension.
Fig. 22: Blade tension
Adjusting the upper saw band guide
Before each sawing process, the upper saw band guide
must be adjusted depending on the workpiece height.
The upper saw band guide must be approx. 3 mm above
the workpiece.
Step 1: Open the clamping screw of the saw band guide
and adjust the height with the aid of the adjusting
handle. Then fix the adjustment handle again.
(Fig.23)
Fig. 23: Adjust the position of the upper strap guide
DANGER!
The saw blade tension must be checked before each
use!
WARNING!
Excessive saw blade tension can cause saw blade
breakage and serious injury.
Too low a saw blade tension can lead to slippage of
the tape guide rollers and thus to the standstill of the
saw blade.
Therefore always pay attention to a correct setting of
the saw blade tension!
Inclination
NOTE!
After completion of the working shift, the saw band is
to be released again with the rotary knob.
NOTE!
Check the tension by pressing your finger halfway
between the table and the top guide against the side
blade.
The ideal tension is about 2mm.
Blade tension
Handle
Handle
upper saw band
guide